How to deal with water leakage in pvc joints

May 29, 2024, 11:58 AM

TDDchem.com

6714

First, check the water leakage of the PVC joint. If the leakage is not very serious, you can first clean the water stains at the leakage area, then prepare an AB sealant, apply it to the leakage area of the PVC joint, and then wrap a layer of leak proof sealing tape. If the water leakage is serious, it is necessary to first remove the leaking PVC joint, then purchase a PVC joint of the same size and install it.

首先检查一下pvc接头的漏水情况，如果漏水不是很严重，可以先将漏水地方的水渍清理干净，然后准备一支AB密封胶，将其涂抹在pvc接头漏水处，然后再缠绕一层防漏密封胶带就可以了。如果漏水情况比较严重的话，需要先将漏水的pvc接头拆卸下，然后购买一个与该尺寸相同的pvc接头，安装上去即可。

How to repair the leakage of the PVC sewer joint

1. Purchase a new PVC water pipe in advance to replace it. First, cut off the broken pipe, and then insert the connector into one side of the pipe. Align the cut area on the other side with the other opening of the connector, so that it can be kept straight. Then, send it into this end to ensure that the two ends intersect. Then, remove it and apply PVC glue to the outside of the drainage pipe and water pipe on both sides.

2. You can also choose to purchase waterproof adhesive tape to repair the leak, wrap the tape around the leak, and then apply cement mortar and waterproof agent to it.

pvc下水管接头漏水怎么修补呢

1、预先购买一个新的PVC水管回来替换，先将坏掉的管子剪断，然后再把接口套进管道的一边，让另一边切断的地方和接口的另一个口子对齐，让他能够保持平直，再把它送进这端，确保两端有交叉，之后再把它拆卸下，拿PVC胶水涂抹在两边的下水管和水管外侧。

2、也可以选购防水胶带来将漏水的地方修补，把胶带缠绕在漏水处，再用水泥砂浆和防水剂抹上去即可。

Recommand products from LYDD:

Nantai Titanium dioxide NR-9502 for coating&paint

Polypropylene 548RQ

PVC sports floor

What is PVC gray powder?